Front Tine TillerModel 393OPERATOR’S MANUALIMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLYMTD LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019W
10Handle PressureFurther control of tilling depth and travel speed can be obtained by variation of pressure on the handles. • A downward pressure on t
11SECTION 5: MAKING ADJUSTMENTSWARNING: Disconnect the spark plug wireand ground it against the engine beforeperforming any adjustments.Engine Adjust
12Cleaning Tine Area Clean the underside of the tine shield after each use. The dirt washes off the tines easier if rinsed off immediately instead of
13Figure 16• Be certain to adjust the clutch control as instructed in the final clutch adjustment section of assembly instructions.Off-Season StorageI
14Model 390123456278910111213141516222324252627282930313233343536373839404142303730434445464748491719202118
15Model 390REF. NO.PART NO. DESCRIPTION1. 712-0442 Acorn Lock Nut 1/4-202. 736-3020 Flat Washer .271” I.D. x .630” O.D.3. 720-0270A Reverse Handle Gri
16Model 390317182119164344464745711216891015144538412240423639331213302932313435282749482526242423205051
17Model 390REF. NO.PART NO. DESCRIPTION1. 712-0392 Hex L-Stop nut 1/4-282. 736-3020 Flat Wash. .266” I.D. x .625” O.D.3. 710-0599 Hex Washer TT-Tap Sc
18Notes:
19Notes:
2TABLE OF CONTENTSContent PageImportant Safe Operation Practices... 3Assembling Your T
MANUFACTURER’S LIMITED WARRANTY FOR:The limited warranty set forth below is given by MTD LLC with respect to new merchandise purchased and used in the
3SECTION 1: IMPORTANT SAFE OPERATION PRACTICESWARNING: This symbol points out important safety instructions which, if not followed, could endangerth
49. Look down and behind and use care when in reverse or pulling machine towards you.10. Start the engine according to the instructions found in this
5SECTION 2: ASSEMBLING YOUR TILLERNOTE: References to right or left side of the tiller aredetermined from behind the unit in the operatingposition.Re
6Attaching Clutch Control Cable(s)Forward CableAttach the end of the forward cable to the bracket underneath the handle assembly as follows. The forwa
7SECTION 3: KNOW YOUR TILLERWARNING: Read, understand, and followall instructions and warnings on themachine and in this manual beforeoperating.Throt
8SECTION 4: OPERATING YOUR TILLERGas and Oil Fill upService the engine with gasoline and oil as instructed in the separate engine manual packed with
9Removing End Caps The end cap, which are used to avoid tilled soil from overflowing onto unwanted areas, are removable from the outer axle. Remove th
Kommentare zu diesen Handbüchern